PK 19.001 SLD 5
SOLID, SIMPLE AND AFFORDABLE
- Additional applications with Single Link Plus
- Higher payloads due to intelligent lightweight design
- Maximum reliability due to PALTRONIC
- High degree of user-friendliness thanks to optional radio remote control
- More lifting power due to A-HPLS
High Power Lifting System
The PALFINGER High Power Lifting System (E-HPLS, A-HPLS or S-HPLS) increases the capacity of the crane by up to 15% while reducing working speed. E-HPLS can be activated manually for the occasional manipulation of very heavy loads. A-HPLS as well as S-HPLS are activated fully automatically. There is continuous activation depending on the power required.
Read More
Single Link Plus
The knuckle joint significantly improves the crane’s motion geometry.
Technical Data
| Max. lifting moment | 18.5 mt |
| Max. lifting capacity | 6200 kg |
| Max. hydraulic outreach | 14.8 m |
| Max. manual outreach | 19 m |
| Slewing angle | 420° |
| Slewing torque | 2 mt |
| Stabilizer spread (std) | 5 m |
| Width folded | 2.55 m |
| Fitting space required (std) | 0.83 m |
| Max. operating pressure | 360 bar |
| Pump capacity | 60 – 80 l/min |
| Dead weight (std) | 1700 kg |
Cranes shown in the leaflet are partially optional equipped and do not always correspond to the standard version.
Country-specific regulations must be observed. Dimensions may vary. Subject to technical changes, errors and translation mistakes.
 Lifting moment(mt) |
 Outreach(m) |
 Slewing angle(°) |
 Slewing torque(mt) |
 Pressure(MPa) |
 Pump capacity(l/min) |
 Crane Weight(kg) |
 Crane Height(mm) |
 Crane Width(mm) |
 Installation Width(mm) |
|
| Std | 18.5 | 6.1 | 420 | 2 | 36 | 60-80 | 1700 | 2250 | 2550 | 825 |
| A | 18.1 | 8.2 | 420 | 2 | 36 | 60-80 | 1855 | 2250 | 2550 | 825 |
| B | 17.7 | 10.4 | 420 | 2 | 36 | 60-80 | 1990 | 2250 | 2550 | 825 |
| C | 17.3 | 12.6 | 420 | 2 | 36 | 60-80 | 2105 | 2250 | 2550 | 895 |
| D | 17 | 14.8 | 420 | 2 | 36 | 60-80 | 2205 | 2250 | 2550 | 895 |
The outreaches stated are with a boom angle of 20° and are therefore not the maximum. When using mechanical boom extensions, the loads shown on the charts need to be reduced by the weight of these extensions.
